Preheat
The preform (embryo) is irradiated by the infrared high temperature lamp, and the preform (embryo) body is partially heated and softened. In order to maintain the shape of the bottle mouth, the preform (embryo) mouth does not need to be heated, so a certain cooling device is required to cool it.
Bottle Blowing Molding
In this stage, the preheated preform (preform) is placed in the prepared blow mold, the high-pressure inflation is carried out in it, and the preform (preform) is blown and pulled into the required bottle. The cosmetic bottle blowing machine combines the two operations of bottle blowing through the operation of a manipulator, which eliminates the process of manually putting the preheated preform (embryo) into the blowing mold in the middle, and greatly speeds up the production rate.
Operating Specifications
1. Before starting each shift, lubricating oil must be added to each moving part (manipulator, manipulator guide rail, mold opening and closing guide rail).
2. The swing arm can be increased once every (3-4) days, and the large chain and small chain of the heater can be increased once a month. Frequently check whether the main engine reducer and the heater reducer are lack of oil. The main engine bearing can be increased once every 3 months.
3. Before production, check whether the moving parts are firm, whether the screws are loose and fall off, especially where the impact is strong, and whether the belt drive part is abnormal.
4. Check whether the high pressure air source, low pressure air source, power supply and water source are normal.
5. Check whether all emergency stop switches, safety door switches and protective device detection switches are normal.
6. Check whether the heating head enters the embryo and the embryo dropping part works normally. If the embryo is not inserted properly, adjust the nut of the embryo pressing device.
7. Check whether the lamp tube is damaged or broken, and replace it in time.
8. Check whether the pneumatic components leak and act sensitively.
9. Check whether the triplet leaks abnormally, whether it is blocked, and whether the water storage capacity of the water cup is too full.
10. If the solenoid valve of the cosmetic bottle blowing machine is abnormal, it should be cleaned in time (once every 3.5 million bottles).